What you need to know about car door actuator

car door

What you need to know about car door actuator

A door actuator is an electronic device that releases the latch of the passenger door. The device is programmed to be activated by a button, switch or manual radio signal. It is generally mounted inside the door frame and operates in a push or pull principle.

When installing the device turns your manual door lock with automatic locking. The device also acts as a key alarm system that easily can be operated using a remote control.

To make your job easier, you should find a actuator kit has all the tools you need to install the device.

Device Location

The device is in the door of his auto-down latch. In some modern cars, you can I find built into your car system so it can be easily traced.

The device receives voltage from the control switch. When the power door lock is activated received and electromagnetism generated. If the actuator has an electric motor design, it is not a gearset that opens and closes the doors of his car.

How to install the actuator

If your car does not have the actuator should consider installing it. You should start by prying the lock switch energy and power window switch panel door. Then you must disconnect from the door before putting aside the switch.

When removing the door panel of the door should lift the panel up to clear the top of the door. Then connect the window switch must return to and close the window. After closing the window must remove the switch.

You must unplug the spiral cable from the base to lock and remove the door actuator using the socket set. Next, you move the actuator such that are able to allow the locking bar to slide free eyelet.

You must remove and replace the actuator by hand and then connect the new actuator on the locking bar. Finally, you must screw the new door actuator and connect the flexible cable wiring.


Here’s what you need to know about the door lock actuator. If your car does not have or want to replace it, you should ensure that the work is handled by an experienced locksmith. You should do your research and make sure that the candidate has installed actuators before.